Tabla de contenido
Publicidad
UCC T3 installation guide
www.renishaw.com
Connecting the UCC T3 to the host PC
USB connection
Renishaw's UCCsuite software includes all the necessary drivers and utilities to permit the system to be commissioned and operate under the
I++ DME interface protocol. The UCC T3 communicates to the host PC using a USB1.1 communication link. This limits the maximum USB
cable distance between the units to 5 m.
Software installation
The UCC T3 controller is supported on UCCsuite version 4.4.5 software or later.
The UCCsuite software is automatically installed when the application is run
The software can be obtained online at
Follow the prompts to install the UCCsuite software by clicking on the "Next or "Yes" buttons as appropriate
When the "Installation successfully completed" screen appears, you are ready to connect your UCC T3
Earth bonding scheme to achieve an adequate level of protective earthing and RF
immunity
Issued 04 2019
www.renishaw.com/cmmsupport
or from your local Renishaw supplier
21
Publicidad
Tabla de contenido
