Charging The Battery Pack - Toro PowerPlex 14in 40V MAX Manual De Instrucciones

Shutting Off the Trimmer
To shut off the trimmer, release the trigger.
Whenever you are not using the trimmer or are
transporting the trimmer to or from the work area,
remove the battery pack.
Removing the Battery Pack
from the Trimmer
Press the battery latch on the machine to release the
battery pack and slide the battery pack out of the
machine (Figure 8).
1. Battery latch

Charging the Battery Pack

Important:
Read all safety precautions.
Important:
Charge the battery pack only in
temperatures that are within the appropriate
range; refer to Specifications (page
Note:
At any time, press the battery-charge-indicator
button on the battery pack to display the current
charge (LED indicators).
1. Make sure that the vents on the battery pack are
clear of any dust and debris.
2. Line up the cavity in the battery pack
with the tongue on the charger.
Figure 8
9).
(Figure
1. Battery pack cavity
2. Battery pack terminals
3. Battery pack venting areas
3. Make sure that the vents on the battery charger
are clear of any dust and debris.
4. Slide the battery pack into the charger until it is
g192774
fully seated
9)
1. Charger venting areas
2. Left indicator light
5. To remove the battery pack, slide the battery
backward out of the charger.
6. Refer to the following table to interpret the LED
indicators on the battery charger.
10
Figure 9
4. Battery-charge-indicator
button
5. LED indicators (current
charge)
(Figure 10).
Figure 10
3. Right indicator light
g228487
g194423