Charging The Battery Pack - Toro Power Plex 51130 Manual Del Usuario

Charging the Battery Pack

Important:
Make sure to read all safety
precautions.
Important:
Charge the battery pack only in
temperatures that are within the appropriate
range; refer to Specifications (page
Note:
At any time, press the battery-charge-indicator
button on the battery pack to display the current
charge (LED indicators).
1. Plug the power cord that matches your power
outlets into the battery charger.
2. Make sure that the vents on the battery pack are
clear of any dust and debris.
3. Line up the cavity in the battery pack
with the tongue on the charger.
Figure 10
1. Battery pack cavity
2. Battery pack terminals
3. Battery pack venting areas
4. Make sure that the vents on the battery charger
are clear of any dust and debris.
5. Slide the battery pack into the charger until it is
fully seated (Figure
10).
(Figure
4. Battery-charge-indicator
button
5. LED indicators (current
charge)
11).
10)
1. Charger venting areas
2. Left indicator light
6. To remove the battery pack, slide the battery
backward out of the charger.
7. Refer to the following table to interpret the LED
indicators on the battery charger.
Left Light
Off
Red
Green
Orange
g192748
Red Blinking
12
Figure 11
3. Right indicator light
Right Light Indicates:
Charger is on; no battery
Red
pack inserted
Red Battery pack is charging
Red Battery pack is charged
Red Battery pack is too warm
Red Replace the battery pack
g194423