Rotating The Hedge Trimmer Handle; Shutting Off The Hedge Trimmer; Removing The Battery Pack; Operating Tips - Toro Flex-Force Power System 51855T Manual Del Operador

5. Press the lock switch and then squeeze
the trigger switch while engaging the
auxiliary-handle switch to turn on the hedge
trimmer (Figure 4).
The trimmer stays on as long as the
auxiliary-handle switch is engaged and the
trigger is squeezed. You may release the
lock switch once the hedge trimmer is running
(Figure 4).
Rotating the Hedge Trimmer
Handle
1. Press and hold the rotational lock button (A of
Figure 5).
2. Rotate the handle 90° to the right or left
depending on desired cutting direction, then
release the rotational lock button to lock the
handle in the desired position (B of Figure
Figure 5
Shutting Off the Hedge
Trimmer
To shut off the hedge trimmer, release the trigger,
auxiliary-handle switch, or both
least 5 seconds for the cutting blade to stop moving.
Whenever you are not using the trimmer or are
transporting the trimmer to or from the work area,
remove the battery pack.

Removing the Battery Pack

Press the battery latch on the tool to release the
battery pack and slide the battery pack out of the tool
(Figure 6).
5).
1. Battery latch

Operating Tips

•
Use the power tool for cutting in either direction in
a slow, sweeping action from side to side.
•
When trimming new growth, use a wide sweeping
action so that the stems are fed directly into the
cutting blade.
g308389
•
Use a non-powered hand saw or pruning saw to
trim stems that are too large.
•
If desired, you can use a string to help cut your
hedge level. Decide how high you want the hedge.
Stretch a piece of string along the hedge at the
desired height. Trim the hedge just above the
guide line of string.
8
(Figure 4). Allow at
Figure 6
g308388