Carson Reflex Wheel ultimate touch 2.0 Manual De Instrucciones página 65

RX setup
Set up the receiver. RX setup menu are like the picture
• Bind with a receiver: the transmitter enters in bind mode.
Once the receiver correctly bound, press the back button to
return to normal operation (picture
• RX battery monitor: monitors the receiver battery voltage
(picture ).
• External sensor: do not monitor the receiver power supply
voltage but use an external sensor instead. This is useful when
Selecting a transmission system:
• select the correct standard
• the correct transmission standard compatible with the receiver
is selected here
• factory setting "AFHDS 2A"
.
• Low voltage: set the minimum voltage when the battery is
).
• Alarm voltage: set the voltage under which an audible alarm
• High voltage: set the maximum voltage when the battery is
the receiver is powered by an ESC. Connect the external sensor
directly to the main battery.
almost empty (picture ).
rings and the receiver battery icon in the top tray blinks.
full.
65 // GB