Carson Reflex Wheel ultimate touch 2.0 Manual De Instrucciones página 67

Choose sensors:
the main screen can display the
value of up to 4 sensors. This
function selects which sensors
to display. Select the main
screen slot to attribute (1 to 5).
The currently attributed sensor
is displayed.
The next menu lists all
available sensors. Touch the
desired sensors or press the
back button to cancel.
Speed and distance: As
shown in picture, if a rotation
speed sensor is connected
to the receiver, this function
set up the virtual speed and
odometers sensors.
Speed sensor: Select the
rotation speed sensor to use. If
none is selected, this function
is disabled.
Press the interface setup
button corresponding to the
desired servo or touch Cancel
to return.
If an interface setup button
is pressed, a message box
indicates what assignment
was made.
Set rotation length: Set
the vehicle travel distance
corresponding to one rotation
speed sensor. This distance
is used to control the virtual
speed and odometers sensors.
Touch „Set rotation length" to
set distance traveled by the
vehicle in one revolution of
wheel or gear (Unit: mm). As
shown in picture 2, touch back
button to go back.
67 // GB