Cleaning The Shaver In The Smartclean System - Philips Norelco 7000 Serie Manual De Instrucciones

ENGLISH
30
C
4 Place the cleaning cartridge in the
SmartClean System.
C
5 While holding the SmartClean System with
one hand, gently push the top part of the
SmartClean System back down. You will
hear a 'click'.
When the SmartClean System is ready for use,
do not move appliance to prevent leakage.
Cleaning the Shaver in the
SmartClean System
◗ If the shaver does not contain enough power
for one (1) shave, the SmartClean System
may not work properly. Charge the shaver
in the SmartClean System before using the
SmartClean System to clean your shaver.
◗ If you use the shaver with shaving foam or gel,
quickly rinse under hot water before cleaning
in the SmartClean System.
Connect the small plug to the SmartClean
1
System. Connect the power plug into any
100V to 240V AC outlet. Use only the
power cord provided.
2. Place the SmartClean System on a flat,
level surface. Make sure the seal has been
removed from the cleaning cartridge (see
'Preparing SmartClean System For Use').
C
3 Press the top cap down to open the
SmartClean System.
C
4 Shake off any excess water from shaver
before placing in the SmartClean System.
C
5 Hold the shaver head side down above the
shaver holder.
C
6 Place the shaver into the holder (1), push
1
shaver back (2) and press down the top
cap to connect the shaver (click).
2
The shaver will only fit in the SmartClean System
in one direction.
7 The battery symbol blinks to indicate
shaver is charging.
ENGLISH
31