Cleaning The Shaver In The Smartclean System - Philips NORELCO S9531 Manual Del Usario

ENGLISH
28
C
C
C
5 While holding the SmartClean System with
one hand, gently push the top part of the
SmartClean System back down. You will
hear a 'click'.
When the SmartClean System is ready for use,
do not move appliance to prevent leakage.
Cleaning the Shaver in the
SmartClean System
◗ SmartClean System has two phases: a cleaning
phase and a drying phase.
◗ If the shaver does not contain enough power
for one (1) shave, the SmartClean System
may not work properly. Charge the shaver
in the SmartClean System before using the
SmartClean System to clean your shaver.
◗ If you use the shaver with shaving foam or gel,
quickly rinse under hot water before cleaning
in the SmartClean System.
Connect the small plug to the SmartClean
1
System. Connect the power plug into any
100V to 240V AC outlet. Use only the
power cord provided.
Press the top cap to open the SmartClean
2
System.
3. Place the SmartClean System on a flat,
level surface. Make sure the seal has been