Digital Keys; Enter Key; Change Key; Delete Key - Comelit 3471 Manual Tecnico

1.3. Digital keys

The use of RFID keys can only be managed when "access
control" mode is enabled
ONLY WITH "ACCESS CONTROL" ENABLED

1.3.1 ENTER KEY

1.3.2 CHANGE KEY

1. Access programming mode, see page 17.
2. Select data management/keys/(enter/change) by scrolling
through the menu using
confirm.
3. Enter the name for which you wish to assign/change the key
(in full or just the first letter).
M_
ESC
4. Press to start searching.
5. Scroll using
and/or press
selected name.
ESC
» The red and green LEDs flash alternately to indicate that the
device is waiting for a key to be registered.
6. Move the key over the RFID sensor.
» The confirmation message "KEY DETECTED COLOUR ..."
will appear on the display.

1.3.3 DELETE KEY

1. Access programming mode, see page 17.
2. Select data management/keys/delete by scrolling through
the menu using
3. Enter the name for which you wish to delete the key (in full
or just the first letter).
M_
ESC
4. Press
to start searching.
5. Scroll using
and/or press
selected name.
6. Press to delete the key or press

1.2.3 CLEAR ALL KEYS

1. Access programming mode, see page 17.
2. Select data management/keys/clear all by scrolling through
the menu using
3. Press
to confirm deletion or press
(see section 2.6)
and pressing or
OK
CANC
or to confirm the
PASS KEY
OK
CANC
or
and pressing to confirm.
OK
CANC
or to confirm the
to exit.
or
and pressing to confirm.
to exit.

1.4. Supercode

1.4.1 ENTER NEW CODE

The supercode (default 778899) is used to access the
programming menus.
1. Access programming mode, see page 17.
2. Select the menu entries: Select data management/supercode/
enter new code by scrolling through the menu using
pressing or
ENTER NEW CODE
to

DEFAULT SETTINGS

OK
SCROLL
3. Change the supercode (max. 6 digits).
ESC
The supercode must be at least 4 digits long
4. Press
to confirm.
1.4.1 DEFAULT SETTINGS
1. Access programming mode, see page 17.
2. Select data management/supercode/default settings by scrolling
through the menu using
The command cannot be cancelled

2. Settings

2.1. Type of download

1. Access programming mode, see page 17.
2. Select: settings/type of download.
2. Choose between:
OFF
USB
RS485
For downloading in RS485 mode, see diagram on page 100
TYPE OF DOWNLOAD
*OFF
USB
RS485
OK
SCROLL

2.2. System parameters

2.2.1 SPEAKER PARAMETERS

2.2.1.1 ENTER AUDIO TIME

1. Access programming mode, see page 17.
2. Select:
parameters/audio time.
3. Enter the desired value:
RANGE = 10 - 180 sec.
to confirm.
OK
ESC
NEW SUPERCODE:
724584
OK
CANC
or
and pressing
OK
ESC
settings/system parameters/speaker
and
to confirm.
21