Name Only; Welcome Message; Change; Enable - Comelit 3471 Manual Tecnico

Ocultar thumbs Ver también para 3471:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 72
3. Select:
YES
NO (default)
4. Confirm.

2.7. Name only

Allows only the name to be displayed, without the user code,
when scrolling through the directory and during a call from a user.
This function is disabled by default.
1. Access programming mode, see page 17.
2. Select settings/name only.
SECOND LANGUAGE
CALL MANAGEMENT
ACCESS CONTROL
NAME ONLY
OK
SCROLL
3. Select:
YES
NO (default)
4. Confirm.

2.8. Welcome message

This function (not enabled by default) can be used to enter a welcome
message (MAX. 40 characters over 4 lines, in block capitals).
The welcome message alternates with the normal information screens
every 4 seconds.
the message cannot be switched to the second
N.B.:
language when the
(see section "2.4 Second language").

2.8.1 CHANGE

It is possible to enter the welcome message using software Art. 1249B.
1. Access programming mode, see page 17.
2. Select menu options: settings/welcome message/change.
WELCOME
SCROLL
ESC
3. Enter the welcome message.
or:
Delete the existing message and enter a new message.
4. Confirm.

2.8.2 ENABLE

The "initial message" function is disabled by default.
If activated, the welcome message will appear and remain on the
display after a 30-second period of inactivity.
1. Access programming mode, see page 17.
2. Select: settings /welcome message/enable.
WELCOME MESSAGE
YES
*NO
OK
SCROLL
3. Confirm to enable the message.
26 26
OK
ESC
"SECOND LANGUAGE" function is on
OK
CANC
OK
ESC

2.8.3 STATIC MESSAGE

The "initial message" function is disabled by default.
If activated, the welcome message will appear and remain on the
display after a 30-second period of inactivity.
1. Access programming mode, see page 17.
2. Select: settings/welcome message/static message.
STATIC MESSAGE
YES
*NO
OK
SCROLL
3. Select:
YES
NO (default)
4. Confirm.

2.9 Screensaver

If this function is enabled (it is disabled by default), the screensaver will
appear after a 30-second period of inactivity.
1. Access programming mode, see page 17.
2. Select: settings/screen saver.
SCREEN SAVER
YES
*NO
OK
SCROLL
3. Select:
YES to enable the function.
NO to disable the function.
4. Confirm and/or press
to exit.

2.10 Keypad sensitivity

This parameter can be used to set how sensitive the keypad is to being
touched.
1. Access programming mode, see page 17.
2. Select: settings/keypad sens.
KEYPAD SENS.
LOW
*MEDIUM
HIGH
OK
SCROLL
3. Choose between:
low
medium (default)
high
4. Confirm.
OK
ESC
OK
ESC
OK
ESC

Publicidad

Tabla de contenido
loading

Tabla de contenido