Technical Specifications - HQ-Power PROMIX230DSP Manual Del Usuario

38. Unbalanced Master Output (Low)
Output is provided by standard unbalanced phono sockets. Level = 0dBu (775mV RMS), output impedance = < 50 ,
load impedance = 5k
39. AC Power Socket
A standard IEC socket is provided to connect the mixer via the supplied lead to the local AC power supply. The power
consumption of this mixer is 15V.
WARNING: THIS MIXER MUST BE EARTHED FOR SAFETY AND GOOD GROUNDED PRACTICES IN MIXING
In the event of ground-loop problems in the audio system, DO NOT disconnect the AC supply earth to any equipment before
consulting the equipment instruction manual. Most power amplifiers have audio ground lift switches or are designed
specifically to avoid ground-loop problems connected to earthed mixers.
Ensure the mixer has a clean AC supply from the mains socket that is not used for other equipment that would lead to
interference such as lights, refrigerators, etc.
The IEC power socket has an internal fuse holder that takes a 20mm fuse. Always replace a blown fuse with the same type
as specified on the rear of the mixer. Always disconnect the AC power cord before changing the fuse.
40. Earth Stud
This is an earth point for auxiliary equipment, e.g. a turntable.

5. Technical Specifications

Parameter
Sensitivity
Input Impedance
S/N Ratio
Frequency Response
THD
Microphone Equalisation
Microphone
Override Depth
Music Channel Equalisation
Headphones
Load
Power
Output Level (Unbalanced)
Headphones
Load
Power
Dimensions
Weight
Power Supply
Use this device with original accessories only. Velleman nv cannot be held responsible in the event of damage or
injury resulted from (incorrect) use of this device.
For more info concerning this product, please visit our website www.hqpower.com.
The information in this manual is subject to change without prior notice.
PROMIX230DSP
max.
Mic
- 52dBu (2mV)
2k
> 65dB
20Hz ~ 26kHz
< 0.05%
HI = ± 12dB @ 6kHz
LO = ± 12dB @ 80Hz
- 12dB on music channels
HI = ± 12dB
- 26dB @ > 10kHz
MID = ± 12dB @ 1kHz
- 26dB @ 1kHz
LO = ± 12dB
- 26dB @ < 100Hz
32 min.
125mW (2.0V RMS) @ 32
Low
High
Max. Output (w/out clip)
32 min.
125mW (2.0V RMS) @ 32
254 x 120 x 341mm
4.2kg
230VAC/50Hz
Phono
- 42dBu (5.5mV)
47k
> 75dB
RIAA
0dBu (0.775mV RMS)
+ 6dBu (1.55V RMS)
+ 16dBu (4.88V RMS)
7
CD/Line
- 8dBu (300mV)
50k
64dB
20Hz ~ 26kHz
< 0.005%
HQPOWER