H-6101 WALL MOUNTING
Use this method to mount the receptacles to a wall/pole
using the H-6101 Wall Mount Bracket.
1.
Remove pole bracket from spline by inserting key
in hole on top of bracket. Press key down and rotate
clockwise.
2. To mount spline to receptacle, insert 5/16" bolts with
washers through spline and body bracket. Apply
lock washers and nuts inside receptacle and tighten.
3. Attach pole bracket to wall/pole with bolts or screws
(not included) using pre-drilled holes in bracket.
4. Attach spline back into pole bracket to secure to
wall/pole. Insert key in hole on top of bracket. Press
key down and rotate counterclockwise to lock.
PAGE 3 OF 9
MOUNTING CONTINUED
1-800-295-5510
uline.com
Pole Bracket
Body Bracket
Key Hole
Spline
Receptacle
Figure 7
0321 IH-5168