General Safety Rules For Chain Beam Saws - skilsaw SPT55 Instrucciones De Funcionamiento Y Seguridad

Power tool use and care
Do not force the power tool. Use the correct
power tool for your application. The correct
power tool will do the job better and safer at the
rate for which it was designed.
Do not use the power tool if the switch
does not turn it on and off. Any power tool
that cannot be controlled with the switch is
dangerous and must be repaired.
Disconnect the plug from the power source
and/or remove the battery pack, if detachable,
from the power tool before making any
adjustments, changing
storing power tools. Such preventive safety
measures reduce the risk of starting the power
tool accidentally.
Store idle power tools out of the reach of
children and do not allow persons unfamiliar
with the power tool or these instructions
to operate the power tool. Power tools are
dangerous in the hands of untrained users.
Maintain power tools and accessories. Check
for misalignment or binding of moving parts,
breakage of parts and any other condition

General Safety Rules for Chain Beam Saws

Keep hands and legs away from the saw
chain and guide bar when the chain beam
saw is operating. A moment of inattention
while operating the chain beam saw can
cause entanglement of your clothing or body
with the saw chain.
Keep hands away from cutting area. Keep
your second hand on auxiliary handle. If
both hands are holding the saw, they cannot
be cut by the saw chain, and the chain beam
saw can be effectively guided, and any
kickback can be controlled effectively.
Hold the chain beam saw by insulated
gripping surfaces only, because the saw
chain can contact hidden wiring or its
own cord. Saw chains contacting a "live"
wire can make exposed metal parts of the
power tool "live" and could give the operator
an electric shock.
Wear eye protection. Appropriate protective
equipment for face and eyes, hands, legs,
and feet is recommended. Adequate protective
clothing will reduce personal injury by flying
debris or accidental contact with the saw chain.
4
accessories, or
that may affect the power tool's operation.
If damaged, have the power tool repaired
before use. Many accidents are caused by
poorly maintained power tools.
Keep cutting tools sharp and clean.
Properly maintained cutting tools with sharp
cutting edges are less likely to bind and are
easier to control.
Use the power tool, accessories and tool bits
etc. in accordance with these instructions,
taking into account the working conditions
and the work to be performed. Use of the
power tool for operations different from those
intended could result in a hazardous situation.
Keep handles and grasping surfaces dry,
clean and free from oil and grease.
Slippery handles and grasping surfaces do
not allow for safe handling and control of the
tool in unexpected situations.
Service
Have your power tool serviced by a
qualified repair person using only identical
replacement parts. This will ensure that the
safety of the power tool is maintained.
Do not operate the chain beam saw in a
tree, on a ladder, from a rooftop, or any
unstable support. Operation of a chain beam
saw in this manner could result in serious
personal injury.
Always keep proper footing and operate the
chain beam saw only when standing on fixed,
secure, and level surface. Slippery or unstable
surfaces such as ladders can cause a loss of
balance or control of the chain beam saw.
Carry the Chain Beam Saw by the auxiliary
handle with the chain beam saw switched
off and the saw chain away from your
body. When transporting or storing the
chain beam saw always fit the guide bar
cover. Proper handling of the chain beam
saw will reduce the likelihood of accidental
contact with the moving saw chain.
Follow instructions for lubricating, chain
tensioning, and changing bar and chain.
Improperly tensioned or lubricated chain can
either break or increase the chance for kickback.
Keep handles dry, clean, and free from oil
and grease. Greasy, oily handles are slippery
causing loss of control.