GB
F
D
E
I
P
IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM, CONTACT YOUR AUTHORISED SERVICE DEALER.
PROBLEM
Grass wraps round shaft
housing and string head.
Bump knob hard to turn.
Lubricant drips from muffler.
NOTE: If your unit exhibits specifi c performance problem(s) where the Troubleshooting section recommends a clockwise screw
adjustment on the carburetor and no adjustments have been made since original purchase, the unit should be taken to an authorized
service center for repair. In most cases, the needed adjustment is a simple task for the trained service representative.
960720001-01.indd 20
960720001-01.indd 20
NL
S
DK
N
FIN GR HU
English
TROUBLESHOOTING
POSSIBLE CAUSE
1. Cutting tall grass at
ground level.
2. Operating trimmer at
part throttle.
Screws threads dirty or
damaged.
1. Operating trimmer at
part throttle.
2. Check lubricant/fuel mixture. 2. Use fresh fuel and the correct synthetic 2-stroke
3. Air filter dirty.
20
CZ RU
RO PL SLO HR TR EST LT
SOLUTION
1. Cut tall grass from the top down.
2. Operate trimmer at full throttle.
Clean threads and lubricate with grease - if no
improvement, replace bump knob.
1. Operate trimmer at full throttle.
lubricant mix.
3. Clean per instruction in Maintenance Section.
LV
SK BG
12/6/07 5:37:04 PM
12/6/07 5:37:04 PM