Aerial Connection; Speaker Connection - Sharp XL-UH240W Manual De Instrucciones

Aerial connection

Supplied FM aerial:
Connect the FM aerial wire to the FM 75 OHMS socket and position
the FM aerial wire in the direction where the strongest signal can be
received.
Supplied AM loop aerial:
Connect the AM loop aerial to the AM and GND terminals. Position
the AM loop aerial for optimum reception. Place the AM loop aerial
on a shelf, etc., or attach it to a stand or a wall with screws (not
supplied).
ANTENNA
FM
GND AM
75 OHMS
Note:
Placing the aerial on the unit or near the AC power lead may cause
noise pickup. Place the aerial away from the unit for better reception.
Installing the AM loop aerial:
< Assembling > < Attaching to the wall >
Wall

Speaker connection

Connect the black wire to the minus (-) terminal, and the red wire to
the plus (+) terminal.
Caution:
Use speakers with an impedance of 6 ohms or more, as lower
impedance speakers can damage the unit.
Do not mistake the right and the left
channels. The right speaker is the one on the
right side when you face the unit.
Do not let the bare speaker wires touch
each other.
Do not allow any objects to fall into or to be
placed in the bass reflex ducts.
Do not stand or sit on the speakers. You may
be injured.
Speaker Light-Up connection
Connect the speaker light-up wires to the SPEAKERS LIGHT-UP
sockets for speaker illumination. To turn off the speaker light-up
feature, press the CLEAR/DIMMER button on the remote control for
2 seconds or more.
Screws (not supplied)
Note:
Placing the right speaker light-up wire to the RIGHT socket and the
left speaker light-up wire to the LEFT socket.
SPEAKERS
RATED SPEAKER IMPEDANCE:
6 OHMS MIN.
RIGHT LEFT
Red Black
Incorrect
XL-UH240W_8-16.fm
XL-UH240W
ENGLISH
E-8