Memorising A Station; To Erase Entire Preset Memory - Sharp XL-UH240W Manual De Instrucciones

Listening to the radio (continued)
XL-UH240W
ENGLISH

Memorising a station

You can store 40 AM and FM stations in memory and recall them at
the push of a button. (Preset tuning)
1
Perform steps 1 - 3 in "Tuning" on page 24.
2
Press the MEMORY button to enter the preset tuning
saving mode.
3
Within 30 seconds, press the PRESET (
select the preset channel number.
Store the stations in memory, in order, starting with preset
channel 1.
4
Within 30 seconds, press the MEMORY button to store that
station in memory.
If the "MEMORY" and preset number indicators disappear
before the station is memorised, repeat the operation from step
2.
5
Repeat steps 1 - 4 to set other stations, or to change a
preset station.
When a new station is stored in memory, the station previously
memorised for that preset channel number will be erased.
Note:
The backup function protects the memorised stations for a few
hours should there be a power failure or the AC power lead become
disconnected.
E-25
To recall a memorised station
Press the PRESET (
select the desired station.
To scan the preset stations
The stations saved in memory can be scanned automatically.
(Preset memory scan)
1 Press the PRESET (
The preset number will flash and the programmed stations will be
tuned in sequentially, for 5 seconds each.
2 Press the PRESET (
station is located.
or ) button to

To erase entire preset memory

1 Press the ON/STAND-BY button to enter the stand-by mode.
2 Whilst pressing down the
the TUNER (BAND) button until "TUNER CLEAR" appears.
03/12/17 XL-UH240W 17-25.fm
or ) button for less than 0.5 seconds to
or ) button for more than 0.5 seconds.
or ) button again when the desired
1 button and the 5 button, press