Dometic FreshWell 3000 Instrucciones De Montaje página 11

Dometic FreshWell3000
A
NOTICE! Beware of damage
Observe the structural engineering of the vehicle and seal of all
openings made when installing the under-bench air conditioner.
Note on transport
 Always have someone help you carry the under-bench air conditioner.
 Always lift the under-bench air conditioner to move it and never drag it
over the floor (fig. 2 A).
 Do not use the ventilation slots to lift it (fig. 2 B).
Note on installation location
 To install the machine it is necessary to create openings in the floor.
These openings must be accessible and must not be covered by any
parts of the vehicle.
 Before installing the under-bench air conditioner, check whether any vehi-
cle components could be damaged by the installation of the under-bench
air conditioner (such as lamps, cupboards, doors).
 Make sure no combustible objects are stored or installed near the air out-
let. A distance of at least 50 cm should be kept.
 The inclination of the installation surface may not exceed 10°.
 For safety reasons, note the location of existing wiring harnesses, wires
and other components within the installation area, in particular those
which are not visible, when installing the under-bench air conditioner
(when drilling or screwing etc.).
 To obtain the optimal air-conditioning in the vehicle, install the under-
bench air conditioner in a central position, in a compartment or a similar
housing.
 Choose a place that is easily accessible for servicing as well as disassem-
bling and installing.
 Place the assembly template into the chosen compartment and check the
space available for the openings in the floor.
 To minimize the transmission of noise and vibration during operation, the
under-bench air conditioner should have a all around minimum clearance
of 30 mm to walls and furniture.
 The under-bench air conditioner must be installed on the floor.
 Keep a distance of 200 mm between the front of the under-bench air
conditioner and the walls of the compartment to facilitate filter replace-
ment.
EN
Installation
9