Dometic FreshWell 3000 Instrucciones De Montaje página 12

Installation
 Installing the under-bench air conditioner into an external compartment
(e.g. false bottoms), the air to be treated must be drawn in from the
vehicle's passenger compartment.
 Suctioning of outside air can significantly reduce the power of the system.
Note on electrical system (see fig. c)
No. in fig. c Description
1 Motor ventilator (inner)
2 Motor ventilator (outer)
3 Capacitor
4 Compressor
5 Temperature sensor
6 PCB
7 PCB display
8 PCB interface
9 Soft start
10 Valve
11 Resistor
 Only a qualified electrician should connect the under-bench air condi-
tioner to the electrical power.
 Check that the voltage specification on the type plate is the same as that
of the power supply.
 Do not lay cables which are loose or bent next to electrically conductive
material (metal).
 Install an all-pole switch with a contact opening width of at least 3 mm on
the installation side.
10
Dometic FreshWell3000
EN