Air Ducting - Dometic FreshWell 3000 Instrucciones De Montaje

Dometic FreshWell3000
7.8

Air ducting

See fig. b
Make the air ducting with trade parts (not included in the supply). It is recom-
mended to use cardboard pipe for air conditioning with an aluminium core
and external covering of PVC. The nominal inside diameter should size up to
60 mm, the outside diameter 65 mm.
The ventilation pipes are joined by pressing them together thanks to the
tapered hole on the air outlet.
The pipes can be connected either on the outlet on the coil side or, by remov-
ing the guard and closing the front holes, on the side outlet.
To achieve the best efficiency it is recommended to:
 lay the air pipes as short and straight as possible
 restrict the length of the pipes to 5 m
 don't lay the pipes near any heat sources
The recirculation air is drawn in through a grille or through other openings
with a total cross-section of at least 300 cm². The recirculation air opening
must be created near the machine. If this is not possible, make sure that the
air flow must be obstructed by anything; if necessary, create an air duct
between the opening and the machine.
I
NOTE
To avoid condensation on the pipes insulate the pipes with
insulation material (not included in the scope of delivery).
The recirculation air must be taken from inside the passenger compartment;
if taken from the outside then the efficiency of the under-bench air conditioner
will be reduced.
EN
Installation
13