Transport And Storage Of Cordless Tools; Bandsaw Is Not In Working Order; Bandsaw Is In Working Order - Hilti SB 4-A22 Manual Del Usuario

6.2

Transport and storage of cordless tools

Transport
CAUTION
Accidental starting during transport !
▶ Always transport your products with the batteries removed!
▶ Remove the battery.
▶ Never transport batteries in bulk form (loose, unprotected).
▶ Check the tool and batteries for damage before use after long periods of transport.
Storage
CAUTION
Accidental damage caused by defective or leaking batteries !
▶ Always store your products with the batteries removed!
▶ Store the tool and batteries in a place that is as cool and dry as possible.
▶ Never store batteries in direct sunlight, on heating units or behind a window pane.
▶ Store the tool and batteries in a place where they cannot be accessed by children or unauthorized
persons.
▶ Check the tool and batteries for damage before use after long periods of storage.
7 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
7.1

Bandsaw is not in working order

Malfunction
No response from the LEDs.
1 LED flashes.
4 LEDs flash.
7.2

Bandsaw is in working order

Trouble or fault
The tool does not develop full
power.
8 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
22 English
Possible cause
The battery is not correctly in-
serted.
The battery is empty.
Safety lock not pressed.
The battery is discharged.
The battery is too hot or too cold.
Bandsaw momentarily overloaded.
Bandsaw too hot.
Tool is blocked
Possible cause
The control switch is not fully
pressed.
The battery is discharged.
Action to be taken
▶ Push the battery in until it
engages with a double click.
▶ Charge the battery.
▶ Press the safety lock.
▶ Change the battery and charge
the empty battery.
▶ Bring the battery to the recom-
mended working temperature.
▶ Release the control switch and
then press it again.
▶ Allow the bandsaw to cool
down.
▶ Check whether the saw blade is
fitted correctly and/or damaged.
Action to be taken
▶ Press the control switch fully.
▶ Change the battery and charge
the empty battery.
2145463
*2145463*