Cleaning The Guard; Transport And Storage Of Cordless Tools - Hilti SC 60W-A36 Manual Del Usuario

• Avoid ingress of moisture.
Maintenance
• Check all visible parts and controls for signs of damage at regular intervals
and make sure that they all function correctly.
• Do not operate the cordless tool if signs of damage are found or if parts
malfunction. Have the tool repaired by Hilti Service immediately.
• After cleaning and maintenance, fit all guards or protective devices and
check that they function correctly.

7.1 Cleaning the guard

1. Remove the saw blade. → page 11
2. Clean the parts of the guard carefully with a dry brush.
3. Use a suitable tool to remove deposits or cuttings from the inside surfaces
of the parts of the guard.
4. Install the saw blade. → page 12
8

Transport and storage of cordless tools

Transport
CAUTION
Accidental starting during transport !
▶ Always transport your products with the batteries removed!
▶ Remove the battery.
▶ Transport the tool and batteries individually packaged.
▶ Never transport batteries in bulk form (loose, unprotected).
▶ Check the tool and batteries for damage before use after long periods of
transport.
Storage
CAUTION
Accidental damage caused by defective or leaking batteries !
▶ Always store your products with the batteries removed!
▶ Store the tool and batteries in a place that is as cool and dry as possible.
▶ Never store batteries in direct sunlight, on heating units or behind a
window pane.
▶ Store the tool and batteries in a place where they cannot be accessed by
children or unauthorized persons.
▶ Check the tool and batteries for damage before use after long periods of
storage.
9 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable
to remedy the problem by yourself, please contact Hilti Service.
2172267
*2172267*
Printed: 04.06.2018 | Doc-Nr: PUB / 5389747 / 000 / 01
English 15