Waste Handling Material Recycling - Johnson Pump SPX 9092358 Manual De Instrucciones

> English
Service instructions
Disassembly
1. Loosen the five screws holding the pump
body and remove it.
2. Loosen the screw holding the impeller on
the motor shaft with a
3 mm hexagon wrench. Note! Anti-clock-
wise. Remove the impeller.
3. Remove the rotating part of the mechanical
seal from the shaft.
4. Remove the middle part and the ceramic
part of the mechanical seal from the middle
part. Remove the O-ring from the middle
part.
5. Loosen the four screws holding the flange
and remove the flange from the motor.
6. Do not disassemble the motor.
6
Assembly
1. Fit the flange to the motor with the four
screws.
2. Push the ceramic part of the mechanical
seal in its position in the middle part (per-
pendicular within
0.1 mm related to the shaft).
Note! The sealing surfaces of the me-
chanical seal may easily be damaged by
dirt, scratching, grease or other solids in
suspension. Therefore be careful with the
sealing parts and never touch the sealing
surfaces with your fingers.
3. Fit the O-ring in the groove of the middle
part. Lubricate the outside of the O-ring
with a thin layer of grease.
4. Fit the middle part in the flange. The middle
part to be turned so that its stud will guide
into the corresponding groove in the
flange.
5. Fit the rotating part of the mechanical seal
onto the motr shaft.
6. Fit the impeller on the motor shaft. Note!
The screw is anti-clockwise.
7. Fit the body with the five screws.
8. Turn the impeller round to check that it is
running free in the body.
Waste handling
material recycling
At the products end of life, please dispose
of the product according to applicable law.
Where applicable, please disassemble the pro-
duct and recycle the parts material.
Original instructions