Maintenance, Servicing & Repair - Barloworld Scientific stuart SSM1 Instrucciones De Funcionamiento

seconds and minutes (1 second to 90 minutes)
turn the unit off using the control knob then
switch the mains power off at the plug. Hold
down both the start/stop button and the mode
button whilst simultaneously switching the mains
power back on. The display will temporarily
show 88:88 then OFF. Using the control knob
turn the unit on, the display will show nn:ss for
minutes and seconds, H:nn for hours and
minutes and nn for minutes, turn the control
knob to select the desired timer unit and turn
the unit off by the control knob, OFF will be
displayed. When the unit is next used the timer
will have been altered to the set unit.
6. Maintenance, Servicing
& Repair
WARNING: Ensure the unit is disconnected
from the mains electricity supply before
attempting maintenance or servicing.
This range of equipment does not require
routine servicing. The only maintenance required
is to clean external surfaces with a damp cloth
and mild detergent. Spillages or splashes should
be cleaned up straightaway after isolating the
unit from the mains electricity supply.
6.1 Repairs
Any repairs or replacement of parts MUST be
undertaken by suitably qualified personnel.
Only spare parts supplied or specified by
Barloworld Scientific Ltd. or its agent should
be used. Fitting of non-approved parts may
affect the performance of the safety
features designed into the instrument.
For a comprehensive list of parts required by
service engineers conducting internal repairs, or
to receive a service manual, please contact the
Sales Department of Barloworld Scientific Ltd
quoting both the model and serial number.
If in any doubt please contact the Technical
Department of Barloworld Scientific Ltd.
6.2 Accessories
Code Description
SSM5/1 Tube holder for 1.5ml tubes
SSM5/2 Tube holder for 0.5ml tubes
SSM3/1 Tier system (for mini rockers)
SSL3/1 Tier system (for large rockers)
SSM1/1 Cradle system (for SSM1)
SSM1/2 Large platform (for 8 well plates)
for SSM1
SSM1/3 Plastic lid (for SSM1)
SSL1/1 Large platform, 510 x 510mm
7. Warranty
Barloworld Scientific Ltd warrants this instrument
to be free from defects in material and
workmanship, when used under normal
laboratory conditions, for a period of three (3)
years. In the event of a justified claim,
Barloworld Scientific Ltd will replace any
defective component or replace the unit free of
charge.
This warranty does NOT apply if damage is
caused by fire, accident, misuse, neglect,
incorrect adjustment or repair, damage caused
by installation, adaptation, modification, fitting
of non-approved parts or repair by unauthorized
personnel.
Barloworld Scientific Ltd.
Stone, Staffordshire ST15 0SA
United Kingdom
Tel: +44 (0) 1785 812121
Fax: +44 (0) 1785 813748
e-mail equipment@barloworld-scientific.com
www.barloworld-scientific.com
5