Axxess AX-MLOC-HD1 Instrucciones De Instalación

Installation Instructions for AX-MLOC-HD1
A two channel adjustable L.O.C. (Line Output Converter) with a built in amplifier
remote generator, the AX-MLOC-HD1 is designed to convert (2) channels of speaker
level audio into (2) channels of line level audio that can be used by an aftermarket
amplifier. This device will also detect the presence of an audio signal and then
generate a +12V output that can be used to turn-on an aftermarket amplifier .
Features and specifications
watts per channel continuous input without overheating. The input circuitry is
designed to correct the crossover distortion commonly found on standard L.O.C.'s,
while providing a high to low level step down of 6:1. Output audio level is infinitely
adjustable using the onboard, high quality potentiometers. The remote output, or
amplifier trigger, is rated at 500mA (+12V), and will easily handle an outboard
relay if additional current is needed. The remote output will trigger instantaneously
when the LOC detects DC voltage on the white, left + audio input wire above 5V, or
a very low audio signal. It will shut off 60 seconds after no signal is detected
Installation:
output wires. These connectors are found behind the radio in the bike's fairing,
before the speaker pods. We have provided speaker harnesses that can be used to
run the output signal to the speaker without destroying the wiring of the speaker
pod. Please refer to the wiring diagram for the input and output connection details.
Wire color and function:
EIA standard color for car stereo applications as follows:
Yellow battery +12v input
Black ground input
Blue
remote +12v output (the
above power wires can be
connected directly to the
amplifier being added)
White left front (+) input
Loose black connectors:
White
White/Black left front (-) output
Note: Be sure that all audio input connections are polarized or in phase with each
other. Failure to do this will result in poor bass response and low quality audio.
Adjusting the AX-MLOC-HD1 for maximum performance: After completing all of the
necessary connections, turn the adjustment pots all of the way down by rotating them
completely counter-clockwise. Now, turn the stereo system on and adjust the main
volume control on the stereo to approximately ¾ maximum volume. Select one of the
adjustment pots and turn it slowly clockwise until you notice audio distortion, and then
stop. Turn the remaining pot to the same position as the previously adjusted pot. The
audio set-up of the AX-MLOC-HD1 is now complete and ready to be enjoyed.
CAUTION!
All accessories, switches, climate controls panels, and especially air bag
indicator lights must be connected before cycling the ignition. Also, do not remove the
factory radio with the key in the on position, or while the vehicle is running.
© COPYRIGHT 2017 METRA ELECTRONICS CORPORATION
The AX-MLOC-HD1 should be installed on the radios speaker
The audio and power input wire colors are an
left front (+) output
from amplifier
from amplifier
Metra recommends MECP
certified technicians
®
Axxess Integrate
®
: The AX-MLOC-HD1 is able to handle 80
White/Black left front (-) input
Gray
Gray/Black
Brown
Gray
Gray/Black
• axxessinterface.com
right front (+) input
right front (-) input
reference ground (-)
(reference ground
optional if noise is
present)
right front (+) output
from amplifier
right front (-) output
from amplifier
K P
NOWLEDGE IS
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
REV. 4/6/17
.
OWER