Axxess AX-MAZCAM-6V Instrucciones De Instalación

Installation Instructions for AX-MAZCAM-6V
AX-MAZCAM-6V
Mazda Backup Camera Retain/Add-On
2007-2015
INTERFACE FEATURES
• Retains the factory backup camera to an aftermarket radio
• Allows an aftermarket camera to be added to the factory screen
• Includes the AX-CAM6V 12-volt to 6-volt converter
INTERFACE COMPONENTS
• AX-MAZCAM-6V harness • AX-CAM6V 12-volt to 6-volt converter
APPLICATIONS
MAZDA
CX-5
CX-7
CX-9
Mazda6
TOOLS REQUIRED
• Wire cutter • Crimping tool • Solder gun • Tape
• Connectors (example: butt connectors, bell caps, etc.)
CAUTION!
All accessories, switches, climate controls panels, and especially air bag indicator
lights must be connected before cycling the ignition. Also, do not remove the factory radio with
the key in the on position, or while the vehicle is running.
® axxessinterfaces.com • metraonline.com
Axxess Integrate
REV. 9/27/16 © COPYRIGHT 2004-2016 METRA ELECTRONICS CORPORATION
2013-2015
2007-2012
2007-2015
2011-2015
Installation Instructions for AX-MAZCAM-6V
Connections to be made
The AX-MAZCAM-6V can be connected two different ways
To retain the factory backup camera to an aftermarket radio:
• Connect the Black wire to chassis ground, and also to the Black wire of the AX-CAM6V.
• Connect the Yellow wire to the Blue/Red wire of the AX-CAM6V.
• Connect the reverse wire from the aftermarket radio, to the reverse signal in the vehicle,
and also to the Blue/White wire of the AX-CAM6V.
• Connect the male Yellow RCA jack to the rear camera input of the aftermarket radio.
To allow an aftermarket camera to be added to the OEM screen:
• Connect the Black wire to the ground wire of the aftermarket camera.
• Connect the Yellow wire to battery wire of the aftermarket camera.
• Connect the female Yellow RCA jack to the aftermarket camera.
• The AX-CAM6V 12-volt to 6-volt converter will not be used in this application.
IMPORTANT
If you are having difficulties with the installation of this product, please call our
Tech Support line at 1-800-253-TECH. Before doing so, look over the instructions
a second time, and make sure the installation was performed exactly as the
instructions are stated. Please have the vehicle apart and ready to perform
troubleshooting steps before calling.
K P
NOWLEDGE IS OWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
® axxessinterfaces.com • metraonline.com
Axxess Integrate
REV. 9/27/16 © COPYRIGHT 2004-2016 METRA ELECTRONICS CORPORATION
Metra recommends MECP
certified technicians