Axxess AX-MAZCAM Instrucciones De Instalación

Mazda Backup Camera Retain/Add-On
INTERFACE FEATURES
• Retains the factory backup camera to an aftermarket radio
• Allows an aftermarket camera to be added to the factory screen
INTERFACE COMPONENTS
• AX-MAZCAM harness
APPLICATIONS
MAZDA
CX-5
CX-7
CX-9
Mazda6
TOOLS REQUIRED
• Wire cutter • Crimping tool • Solder gun • Tape
• Connectors (example: butt connectors, bell caps, etc.)
CAUTION!
All accessories, switches, climate controls panels, and especially air bag indicator lights must
be connected before cycling the ignition. Also, do not remove the factory radio with the key in the on
position, or while the vehicle is running.
Integrate • AxxessInterfaces.com
© COPYRIGHT 2018 METRA ELECTRONICS CORPORATION
AX-MAZCAM
INSTALLATION INSTRUCTIONS
2007-2015
2013-2015
2007-2012
2007-2015
2011-2015
REV. 8/28/18
Connections to be made
The AX-MAZCAM can be connected two different ways
To retain the factory backup camera to an aftermarket radio:
• Connect the Black wire to chassis ground, and also to the Black wire of the AX-CAM6V.
• Connect the Yellow wire labeled "Camera Power 6V" to the AX-CAM6V (sold separately)* .
• Connect the male Yellow RCA jack to the rear camera input of the aftermarket radio.
• Connect the reverse wire from the aftermarket radio, to the reverse signal in the vehicle.
* It is highly recommended to use the AX-CAM6V (sold separately) to provide the camera with
the proper voltage.
To allow an aftermarket camera to be added to the OEM screen:
• Connect the female Yellow RCA jack to the aftermarket camera.
• Tape off and disregard the following (2) wires, they will not be used in this application;
Black, Yellow
IMPORTANT
If you are having difficulties with the installation of this product, please call our Tech Support
line at 1-800-253-TECH. Before doing so, look over the instructions a second time, and make
sure the installation was performed exactly as the instructions are stated. Please have the
vehicle apart and ready to perform troubleshooting steps before calling.
K P
® NOWLEDGE IS OWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
Integrate • AxxessInterfaces.com
© COPYRIGHT 2018 METRA ELECTRONICS CORPORATION
AX-MAZCAM
INSTALLATION INSTRUCTIONS
Metra recommends MECP
certified technicians
REV. 8/28/18