Axxess AX-MAZCAM Instrucciones De Instalación

Installation Instructions for AX-MAZCAM
AX-MAZCAM
Mazda Back-Up Camera Retain/Add-On
2007-2015
• Retains the factory back-up camera to an aftermarket radio
• Allows an aftermarket camera to be added to the factory screen
INTERFACE COMPONENTS
• AX-MAZCAM harness
APPLICATIONS
MAZDA
CX-5
CX-7
CX-9
Mazda6
TOOLS REQUIRED
• Cutting tool • Tape • Crimping tool
• Connectors (example: butt connectors, bell caps, etc.)
CAUTION!
Metra recommends disconnecting the negative battery terminal before beginning any instal -
lation, unless the vehicle manufacturer recommends against so. Please check with your local Dealership
for more information. All accessories, switches, climate controls panels, and especially air bag indicator
lights must be connected before reconnecting the battery or cycling the ignition. Also, do not remove the
factory radio with the key in the on position, or the vehicle running. It would be best to remove the key
from the ignition and then wait a few seconds before removing the factory radio.
axxessinterfaces.com • metraonline.com
Axxess Integrate
REV. 1/25/16 © COPYRIGHT 2004-2016 METRA ELECTRONICS CORPORATION
FEATURES
2013-2015
2007-2012
2007-2015
2011-2015
Installation Instructions for AX-MAZCAM
Connections to be made
The AX-MAZCAM can be connected two different ways
To retain the factory back-up camera to an aftermarket radio:
• Connect the Black wire to chassis ground.
• Connect the Yellow wire to accessory power.
• Connect the male Yellow RCA jack to the rear camera input of the aftermarket radio.
• Connect the reverse wire from the aftermarket radio, to the reverse signal in the vehicle.
To allow an aftermarket camera to be added to the OEM screen:
• Connect the Black wire to the ground wire of the aftermarket camera.
• Connect the Yellow wire to battery wire of the aftermarket camera.
• Connect the female Yellow RCA jack to the aftermarket camera.
K P
NOWLEDGE IS OWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
axxessinterfaces.com • metraonline.com
Axxess Integrate
REV. 1/25/16 © COPYRIGHT 2004-2016 METRA ELECTRONICS CORPORATION
Metra recommends MECP
certified technicians