GYS START UP 80 Manual De Instrucciones página 14

Translation of the original instructions
• If your engine does not start, do again a 10mn pre-charge cycle before any new attempts to
Nb : If your engine does not start after several attempts, it is because the battery needs to be fully
charged or because there is another breakdown (either mechanical or electrical...)
• After this step,
PROTECTIONS
Your product has been developed with a maximum of protections:
• The clamps of the battery are isolated.
• In case of polarity inversion, a buzzer sounds.
• Polarity inversion and short circuits are not dangerous. The protection is ensured by an automatic internal circuit
breaker, automatically restarting.
• Your machine is protected against over-intensity peaks which can be created by faulty batteries or manipulations.
• Thermal protection: the transformer of the product is protected by a thermal switch (cooling: about ¼ h).
•
SULFATED BATTERIES - START
• This START'UP 80 does not detect sulfated batteries.
Your battery is highly damaged:
- If the charger remains in charge (red or orange indicators on) more than 24h
- If in charge mode the Start'Up 80 indicates, after few seconds, that your battery is charged but after using it, it
appears that it still does not work.
Do not use your charger like an auxiliary power supply. It is forbidden to pull up current from the
battery when the battery is connected to the charger.
14
start it (wait 10 minutes between each cycle).
◦ Unplug the battery charger from the mains supply
◦ then, remove the clamps.
START UP 80
EN