Pioneer SGY-PM930H Manual De Usuario página 15

4. Check the LED display.
The transmitter starts when the
batteries are installed. The LEDs
of the transmitters light as follows
depending on the actual sensor mode.
• When it is in pedaling monitor
mode:
The LEDs light green for 10
seconds
• When it is in dual power meter
mode:
The LEDs light orange for 10
seconds
• When it is in single power meter
mode:
The LEDs blink orange for 10
seconds
LED
Water-proof
packing
Push switch
Installing and Removing the Batteries
• If the LEDs do not light for more
than 5 seconds after installing the
batteries, remove the batteries
once, and after more than 1 minute,
install them again. If the LEDs still
do not light, the battery may be
almost empty. Replace the battery
with a new one. Dispose of useless
batteries as instructed by the local
government.
5. Install the right transmitter
cover and tighten the screws
to fix it in place.
While tightening the screws, do not
use excessive force or over-tighten
them. The plastic cover can crack
if you do so. Use a tool that can
measure the torque to tighten the
screws.
• Tightening torque: 30 cN·m
• Install the transmitter cover and
screw the screws in firmly to ensure
water resistant performance.
EN
15