Switching To The Pedaling Monitor Mode - Pioneer SGY-PM930H Manual De Usuario

Switching to the pedaling monitor mode

EN
• Cyclocomputer SGX-CA600 is required to switch to the pedaling monitor mode. The
mode cannot be switched with cyclocomputers from other manufacturers.
• The firmware version of SGX-CA600 needs to be the latest version. If it is an older
version, update the firmware. Refer to the User's Guide (For WEB) of SGX-CA600
regarding how to update or any other operation method.
http://pioneer-cyclesports.com/us-en/support/products/
• The product mode can be set by using the Cyclo-Sphere Control App.
Refer to the following Website in detail.
https://cyclo-sphere.com/app/
1. Press the [Menu] button on
the data field screen of SGX-
CA600.
2. Select [Bike] - [Tools] -
[Pedaling settings] - [Mode
Switch] in this order.
The mode switching screen opens.
If the device number is already
displayed, confirm that it is the same
as the device number of the sensor
16
you want to use. If it is the same, the
input operation is not required.
If the device number is different from
the sensor you want to use, enter the
new number.
Remove the check from the sensors
whose mode is not to be switched.
3. Select the device number
display part.
The sensor device number input
screen opens.