Switch To Dual Power Meter Mode - Pioneer SGY-PM930H Manual De Usuario

Switch to dual power meter mode

EN
• Both the left and right sensors are required in this mode. Cyclocomputer SGX-CA600 is
required when the sensor changes to the pedaling monitor mode. It cannot be switched
by using cyclocomputers from other manufacturers.
• The firmware version of SGX-CA600 needs to be the latest version. If it is an older
version, update the firmware. Refer to the User's Guide (For WEB) of SGX-CA600
regarding how to update.
http://pioneer-cyclesports.com/us-en/support/products/
The mode can be switched in two ways.
To switch from the pedaling monitor mode to the dual power meter mode, be sure to
use SGX-CA600 and switch with "Method 2" which will be described later. Pedaling
monitor mode cannot be switched to dual power meter mode with "Method 1."
[Method 1] Switch by pushing the
push switch in the right transmitter
• When using a Cyclocomputer from
another manufacturer, switch with
this method.
1. Loosen the screws on the
right transmitter cover and
remove the cover.
Refer to Page 13 to remove the right
transmitter cover.
2. Replacing the batteries of the
left and right transmitters.
Refer to Page 13 regarding how to
install/remove batteries.
20
• The operation is enabled for 5
minutes after the batteries are
installed. Switch within 5 minutes.
If more than 5 minutes elapse, re-
install the batteries of the left and
right sensors.
3. Confirmation of the actual
sensor mode.
When the batteries are installed, the
LEDs on the left and right transmitters
light as follows depending on the
actual sensor mode.
• When it is in pedaling monitor mode:
The LEDs light green for 10
seconds
• When it is in dual power meter mode:
The LEDs light orange for 10
seconds
• When it is in single power meter mode:
The LEDs blink orange for 10
seconds