Pioneer SGY-PM930H Manual De Usuario página 19

Copy pedal
Copy pedal is enabled only in pedaling
monitor mode.
If only the sensor on one side is
operating, you can copy the data on
the other side also to display it for
both sides on the Cyclocomputer
and record it in the log data. You can
select copy pedal of the current bike
and set the balance.
1. Press the [Menu] button on
the data field screen.
2. Select [Bike] - [Tools] - [Ped-
aling settings] - [Pedaling
Copy] in this order.
3. Select [Copy Method] and
select the method that you
wish to copy by.
Switching to the pedaling monitor mode
4. To change the balance, se-
lect [L:R Balance].
5. Change the value by using
the [←] / [Confirm] / [→]
buttons on the top panel of
the product.
• If you set left and right incorrectly,
note that the correct power will not
be displayed.
EN
19