Transport, Storage, Decommissioning And Disposal - Yale Tigrip TCP Manual Del Usuario

14
Attention: Actual operating conditions (e.g. operation in galvanizing facilities) can
dictate shorter inspection intervals.
Repair work may only be carried out by specialist workshops that use original TIGRIP spare
parts. The inspection (mainly consisting of a visual inspection and a function check) must
determine that all safety devices are complete and fully operational and cover the condition of
the unit, suspension, equipment and supporting structure with regard to damage, wear,
corrosion or any other alterations.
Initial operation and recurring inspections must be documented (e.g. in the CMCO works
certificate of compliance).
If required, the results of inspections and appropriate repairs must be verified.
Paint damage should be touched up in order to avoid corrosion. All joints and sliding surfaces
should be slightly lubricated. In the case of heavy contamination, the unit must be cleaned.
Repairs may only be carried out by specialist workshops that use original TIGRIP spare
parts.
After repairs have been carried out and after extended periods of non-use, the load lifting
attachment must be inspected again before it is put into service again.
The inspections have to be initiated by the operating company.
T , S , D D
RANSPORT TORAGE ECOMMISSIONING AND ISPOSAL
Observe the following for transporting the unit:
• Do not drop or throw the unit, always deposit it carefully.
• Use suitable transport means. These depend on the local conditions.
Observe the following for storing or temporarily taking the unit out of service:
• Store the unit at a clean and dry place where there is no frost.
• Protect the unit against contamination, humidity and damage by means of a suitable cover.
• If the unit is to be used again after it has been taken out of service, it must first be inspected
again by a competent person.
Disposal:
After taking the unit out of service, recycle or dispose of the parts of the unit and, if applicable,
the operating material (oil, grease, etc.) in accordance with the legal regulations.
Further information and operating instructions for download can be found at
www.cmco.eu!
©
2016 Columbus McKinnon Industrial Products GmbH