Charging The Battery - ausdom AH850S Manual De Instrucciones

6. Charging the Battery

1.Connect the headphone to a power supply using the included
USB charging cable.
2.Charge the headphone for 2 hours until the solid red LED turns off.
Note:
1. During the first charge, don't disconnect the headphone from
the power supply even if the LED Indicator on the headphone
indicates that the battery is fully charged. Leave it to charge at
least 2 hours in order to ensure fully charged.
2. The LED Indicator flashes red and sounds an alert tone (the
battery voltage is under 3.3V) that indicating the headphone is in
the low battery status. When the battery voltage is under 3.1V,
the headphone will power off.
7. Pairing Configurations
1.Press and hold the power button on the headphone until it
powers on but don't let go just yet. Continue holding down on the
power button until you see the LED indicator flashes blue and
red alternately. It sounds an alert tone to indicate the pairing
mode has been enabled already.
2.Turn on your device, and then enable the Wireless feature.
3.Your Wireless device will list the new device that can be
connected.
4.Select "AUSDOM AH850S". If your device prompts for a code
or PIN, enter "0000". After the connection is made, the LED
Indicator on your headphone turns flashing blue and sounds a
alert tone indicating the wireless connection has been completed
already.
Headset
Micro USB Charging cable
EN-3
Laptop for power supply