Charging The Battery - ausdom AH862 Manual Del Usuario

Bluetooth Headset

5. Charging the Battery

1. Connect the headset to a power supply using the included
USB charging cable.
2. Charge the headset for 2 hours until the red LED Indicator
turns off.
Note:
During the first charge, don't disconnect the headset from the
power supply even if the LED Indicator on the headset indicates
that the battery is fully charged. Leave it to charge at least 2 hours
in order to ensure fully charged.
The LED Indicator flashes red and sounds an alert tone that
indicating the headset is in the low battery status.
6. Pairing Configurations
1. Press and hold the power button for about 4 seconds to enter
"Pairing Mode".
2. Turn on your device, and then enable the Bluetooth feature.
3. Your Bluetooth device will list the new device that can be
connected.
4. Select "AUSDOM AH862". If your device prompts for a code or
PIN, enter "0000". After the connection is made, the LED
Indicator on your headset turns solid blue and sounds "Pairing
successful connected" or "connected" indicating the Bluetooth
wireless connection has been completed already.
Headset
Micro USB Charging cable
- 3-
English
Laptop for power supply