Kuppersbusch GK 30 Serie Instrucciones Para El Uso Y Montaje página 12

Gluing in the hob
Notes
• In order to avoid damage to the worktop and the hob, it is nec-
essary to glue the system worktop/hob with a permanent seal
so that it is water-proof.
• The parts to be glued together must be dry and free from
grease.
• To glue the hob, you require the water-proof wash primer and
the heat and moisture-resistant silicone adhesive (150 °C).
• It is absolutely necessary to observe the remarks concern-
ing these two products. You will find them enclosed
processing indications!
There you will also find a calculation formula for the hardening
of the silicone adhesive. Do not operate the cooking zone
before the hardening process is over as otherwise the sili-
cone adhesive can be damaged.
• Only glue the hob on its outer edges!
• With stone worktops installation is to be flush, with heat-sensi-
tive worktops (e.g. wood) the hob must project about 1 mm.
• Never place the hob with the glass ceramic surface unpro-
tected on the worktop or the floor. Dirt (metal chips, small
pieces of stone etc.) can cause scratches in the surface of the
glass ceramic hob. Please always place it on cardboard or a
wool rug.
Procedure
1. Glue the sealing tape
edge of the worktop so that no silicone adhesive
pressed under the hob.
Important: Only use the sealing tape that is supplied with the
hob! Should you use any other sealing there is no guarantee
that the hob will not sink down after installation.
2. Insert the hob without adhesive into the worktop opening and
check the height. If necessary, place the shims provided on
the support edge for the hob at equal distances to adjust the
height.
3. Remove the hob again.
4. Use the wash primer to pre-treat the outer edges of the hob
and the side cut surfaces of the worktop where they have
been glued.
Apply a thick coat of the primer with a brush on highly
absorbent surfaces (e.g. chipboard). With less absorbent
surfaces (e.g. marble or granite) it is sufficient to apply the
primer with a felt cloth.
Important: After application, the primer must be left for about
30 minutes.
5. Now insert the hob and align.
6. Finally, fill the gap between the hob and the worktop with sili-
cone adhesive .
7. Smooth the joint with a spatula and water containing a little
washing-up liquid.
Attention! Use sealing tape
pressed anywhere under the supporting surface, otherwise it will
no longer be possible to remove the hob at a later stage. No lia-
bility will be assumed in the case of failure to observe these
instructions.
GB
onto the corner of the supporting
can be
! Silicone adhesive may not be
11