Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3. LCD screen
4. Info menu: Allows you to view your sleep statistics
5. Setup menu: Allows you to make changes to settings
6. Push dial: Turning the dial allows you to scroll through the menu and change settings. Pushing the dial allows you
to enter into a menu and confirm your choice.
Navigating the menus
Refer to illustration C.
In general, to navigate the menus:
1.
Turn
until the parameter you require is displayed in blue.
2. Press
. The selection is highlighted in orange.
3. Turn
until you see the setting that you require.
4. Press
to confirm your choice. The screen returns to blue.
Getting started
1.
Make sure the power is connected.
2. Adjust the ramp time if required.
3. Fit your mask as described in your mask user guide.
4. To start therapy, simply breathe into the mask and/or press
5. Lie down and arrange the air tubing so that it is free to move if you turn in your sleep.
6. To stop treatment at any time, remove your mask and/or press
Note: If your clinician has enabled SmartStart your device will start automatically when you breathe into the mask and
stop automatically when you remove the mask.
Cleaning and maintenance
Daily:
Disconnect the air tubing and hang it in a clean, dry place until next use.
Weekly:
1.
Remove the air tubing from the S9 device and the mask.
2. Wash the air tubing in warm water using mild detergent.
3. Rinse thoroughly, hang, and allow to dry.
4. Before next use, reconnect the air tubing to the air outlet and mask.
Monthly:
1.
Wipe the exterior of the S9 with a damp cloth and mild detergent.
2. Check the air filter for holes and blockage by dirt or dust.
Replacing the air filter:
Replace the air filter every six months (or more often if necessary).
1.
Remove the air filter cover from the back of the S9 device.
2. Remove and discard the old air filter.
3. Insert a new ResMed air filter ensuring that it is sitting flat in the air filter cover.
4. Replace the air filter cover.
2
.
.
Publicidad
Tabla de contenido
