X-lander X-DOUBLE Manual Del Usuario página 8

1 U N F O L D I N G T H E F R A M E
Undo the folding blockade (a). Unfold the frame by lifting the handle until the locks
click into position (b).
mechanisms are blocked.
2 M O U N T I N G O F T H E F R O N T W H E E L
To install the wheel, put the front wheel axis into mounting hole until engaged.
3 D I S M O U N T I N G O F F R O N T W H E E L
To remove the wheel, press the button shown in the picture and take it off.
4
AT TAC H I N G O F R E A R W H E E L
To install the wheel, slide it with the axle into the mounting hole until it is engaged.
5 D I S A S S E M B LY O F R E A R W H E E L
To remove the wheel, press the button shown in the picture and take it off.
6 F R O N T W H E E L LO C K
The stroller is equipped with swivel wheels. The slider shown in figures is used to lock
rotation. Press it down to lock the wheels to drive in a straight direction (a).
To unlock the wheel, move the slider up (b).
7 I N S TA L L I N G O F T H E B U M P E R B A R
Push in the ends of the bumper bar into mounting holes, until locks are snapped.
8 TA K I N G T H E B U M P E R B A R O F F
Press the bumper bar lock buttons and slide its ends out of the mounting holes.
9 F O OT R E S T A D J U S T M E N T
Press the buttons on both sides of footrest and adjust it to the required position.
10
R E C L I N I N G S E AT A D J U S T M E N T
To lower the seat, squeeze the lock lever and move the seat down (a).
To lift the seat, grab the belt with one hand, and squeeze the lock lever with other hand
and move the seat up (b).
11
B R A K E
To apply the brake: push the pedal down with your foot. To release the brake pick its bar up.
12 I N C R E A S I N G T H E H O O D I N C L I N AT I O N A N G L E
The hood may be expanded by an additional part. In order to do this, undo the zipper
between the upper and lower part of the hood.
13
B E LT A D J U S T M E N T
To adjust the belt length, move the belt towards a regulator. Regulators are hidden under
protective covers.
14 H A R N E S S B U C K L E FA S T E N I N G A N D R E L E A S E
To fasten the belt buckle, fasten elements 1 and 2, 3 and 4 together. Then slide the joined
elements into the buckle until you hear a click. To release the harness press the round
button in the middle of the buckle and release the straps.
15
M O U N T I N G O F C A R R YC OT
To install the carrycot, slide its adaptors in the bumper bar sockets. *
16
D I S M O U N T I N G O F C A R R YC OT
To take the carrycot off, push the carrycot lock buttons and slide them off the mounting
holes.
17 AT TAC H I N G T H E C OV E R
6
Install as shown in the photo. *
WARNING: Before use, make sure that the folding