Moser 1888 Manual De Instrucciones página 11

Operation
Setting the cutting length
The cutting length can be adjusted to between 0.7 mm
and 3 mm (5 possible positions) using the cutting-
length adjustment integrated into the blade set (Fig. 5).
Cutting with the attachment comb
The appliance can also be operated with attachment
combs.
f In order to achieve the indicated cutting length, the
cutting length adjustment lever should be set to
position 1 (Fig. 5).
Depending on the model, the following attach-
ment combs are included as standard:
3 mm, 6 mm, 9 mm and 12 mm, 18 mm and
25 mm cutting lengths.
Attaching/removing the attachment comb
1. Slide the attachment comb on to the blade set in
the direction of the arrow until it reaches the limit
stop (Fig. 6ⓐ).
2. The attachment comb can be removed by pushing it
in the direction of the arrow (Fig. 6ⓑ).
Maintenance
Cleaning and care
Danger! Electric shock due to penetration
of liquid.
f Switch the appliance off and disconnect
from the power supply, before you start with
cleaning and care.
f Do not immerse the appliance in water!
f Do not allow any liquid to get inside the
appliance.
f Only reconnect the appliance to the power
supply if it is completely dry.
Handle with care! Danger from aggressive
chemicals.
Aggressive chemicals could damage the appli-
ance and accessories.
f Never use solvents or scouring agents.
f Only use cleaning agents and blade set oil
recommended by the manufacturer.
· Hygienic spray and blade set oil are avail-
able from your dealer or our service centre.
Oil and cleaning indicator
·
When the oil and cleaning indicator (C5)
lights up, the blade set urgently needs to
be cleaned and oiled to prevent premature
wear to the appliance.
3. Remove the attachment comb (Fig. 6ⓑ) and lift
the blade set out of the housing (Fig. 7ⓐ). Use the
cleaning brush to remove any cut hairs from the
housing opening and from the blade set (Fig. 8).
The cleaning lever can also be pressed. This allows
the cut hairs that accumulate between the bottom
blade and the top blade to be easily removed using
the cleaning brush (EASY CLEANING).
f Only wipe the appliance with a soft, slightly damp
cloth.
f Clean the blade set regularly using the hygienic
spray.
f Oil the blade set with the blade set oil (Fig. 9).
· For a good and long-lasting cutting perfor-
mance, it is important to oil the blade set
frequently
· If the cutting performance deteriorates
after long use despite regular cleaning and
oiling, the blade set should be replaced.
Changing the blade set
Warning! Injuries and material damage due
to incorrect handling.
f Switch the appliance off and disconnect
from the power supply before changing the
blade set.
1. Switch the appliance off using the on/off switch
(Fig. 3) and disconnect from the power supply.
2. Slide the blade set off the housing in the direction of
the arrow (Fig. 7ⓐ). Remove the blade set.
3. Replace the blade set by hooking it into the hous-
ing and pressing it down until it clicks into position
(Fig. 7ⓑ).
ENGLISH
de
en
fr
it
es
pt
nl
da
sv
no
fi
tr
pl
cs
sk
hr
hu
sl
ro
bg
ru
uk
et
lv
lt
el
ar
11