Operating The Unit; Before You Start - ProMed T-6 Manual Del Usuario

o
27
peratIng the unIt

Before you start:

• Make sure the batteries are installed correctly.
DE
• Connect the cable to the electrode pads and then connect to the
unit.
• Attach the electrode pads to the area of pain.
EN
• Do not use the electrode pads if it is scratched or damaged in
any way.
FR
Check/Replace the battery
IT
ES
NL
1. Remove the Belt Clip (J) by sliding it down the unit.
2. Open the battery compartment cover (I).
3. Insert 4 batteries (type: AAA) into the battery compartment. Make
RU
sure you are installing the batteries correctly. Be sure to match the
positive and negative ends of the batteries to the markings in the
PL
battery compartment of the device.
4. Recover the battery compartment (I) cover if you want to use it.
5. Bring on the Belt Clip (J) back by sliding it upwards the unit.
SE
Caution:
FI
1. Remove the batteries if the device is not in use for long periods of
time.
2. Do not mix old and new batteries or different types of batteries.
3. Warning: If batteries leak and come into contact with the skin or
eyes, wash immediately with copious amounts of water.
4. Batteries must be handled by an adult. Keep batteries out of the
reach of children.
5. Only batteries of the same or equivalent type are recommended.
6. Do not use rechargeable batteries.
7. Remove exhausted batteries from the unit.
8. Dispose of batteries safety according to battery manufacturer's
instructions.
Connect the electrode pads to the cables:
Hold the cable plug and Insert into
electrode pad connections. Make sure
there are no bare metal of the pins ex
posed.
Caution:
Always use the cable that supplied with manufacturer or distributor
and use the electrode pads with CE mark, or are legally marketed in
the US under 510 (k) procedure.
Connect cable to unit
Before proceeding to this step, ensure
the device is completely switched off,
Hold the cable plug and insert into the
socket (B) on the top of the unit.