Bellman Audio Mino Manual Del Usuario página 116

T
116
Adjusting the Tone Control
The Tone Control Blocking function has been developed in case
you want to make it easier for the user to use Mino. This setting
can be used to choose whether or not the user should be able to
adjust the Tone Control. If you choose to switch off the tone control
buttons, you can preset the Tone Control that will be used in user
mode.
Activation and deactivation of Tone Control in User Mode
Press the (9) button to activate the Tone Control buttons.
+
Press the (10) button to deactivate them.
-
The standard setting is Tone Control activated.
Presetting the Tone Control
Press the button (11) and the
<
Control to the level that will be used in user mode.
The standard setting is Tone Control centered (level frequency
response)
Please note that if the Tone Control is activated, the preset value will be
changed as soon as the Tone Control is changed in user mode.
Blocking the T position
The T position can be blocked if you know that the T position will
not be used. This setting is for those who will never use the
position and want to avoid selecting this position by mistake.
Press the (9) button to activate the T position.
+
Press the (10) button to deactivate the T position.
-
The standard setting is activated T position.
Resetting to the factory setting
You can use this to reset all settings to the standard settings
the product was delivered with from the factory.
Press and hold down the
display (8) are lit. After resetting is completed, the display will
blink for a short period.
Version information
The product version information is presented here via a pattern
of lit and blinking LEDs. This internal information is only intended
as an aid for servicing and support.
button (12) to preset the Tone
>
button (9) until all the LEDs on the
+