Bellman Audio Mino Manual Del Usuario página 22

Charging
Mino is supplied with a built-in rechargeable battery. The battery must be charged
before using the product for the first time. Mino contains a Lithium-Ion battery
and a universal charger.
Warning: The product may only be charged with the charger supplied or using
accessories from Bellman & Symfon.
Connect the charger as illustrated in the fold-out section of the manual.
Fit the plug and check that it is locked properly before it is connected to the wall
socket. When the charging connector is connected to the Charger and Mino, the
Battery Status LED (3) changes from green to orange to indicate that charging is
taking place. When charging is finished, after about 2.5 hours, the LED turns green
again.
Function
Connect BE9122 Bellman Stereo Headphones, BE9128 Bellman Neck Loop, BE9125
Bellman Stetoclip, BE9124 Bellman In-ear Phones or another listening product
recommended by Bellman & Symfon to the headphone output (13) on the
right-hand side as illustrated in the fold-out section of the manual.
Switching on
Press the On/Off button
green light to indicate that the unit is on.
Mino always starts with the internal microphone selected as the sound source.
In addition, the volume control is always set to low volume to avoid unpleasant
sound levels.
Selecting the sound volume
Use the volume control's
reduce the sound level. The Volume and Tone LED Indicator (8) shows the sound
level. The more LEDs that are lit, the higher the volume. The LED indicator goes
out 5 seconds after the sound volume has been set.
Selecting the tone
Use the tone control's
the treble in the tone. The Volume and Tone LED Indicator (8) shows the selected
setting. The LED indicator goes out 5 seconds after the sound quality has been set.
Switching off
When you have finished, you can switch off Mino by pressing the On/Off buttons
i
(6) and holding it down until the Battery Status LED (3) goes out.
22
i
(6). The Battery Status LED (3) starts to shine with a
button (9) to increase and the
+
button (11) to reduce and the
<
button (10) to
-
button (12) to increase
>