Getting Started - Bellman Audio Mino Manual Del Usuario

Getting started

Testing
1 Connect the Headphones to the headphone output (13).
2 Give one short press on the On/Off button
3
Listen to the internal microphone and adjust the volume using
the Volume Buttons (
Mino always starts with the internal microphone (1) selected as the sound source.
In addition, the volume control is always set to low volume to avoid unpleasant
sound levels.
The volume control adjusts the sound level by
the volume while the Volume and Tone LED Indicator (8) shows the sound level.
The more LEDs that are lit, the higher the volume. The LED indicator goes out 5
seconds after the sound volume has been set.
The tone control adjusts the sound quality by
the treble. The Volume and Tone LED Indicator (8) shows the tone setting. The LED
indicator goes out 5 seconds after the sound quality has been set.
When you have finished, you can switch off Mino by pressing the On/Off button
(6) and holding it down until the Battery Status LED (3) goes out.
How to use the Bellman Audio Mino
The BE2030 Bellman Audio Mino Professional Communicator is a digital
comunicator which has been specifically developed to provide an exceptional
sound experience even in demanding situations. The Bellman Audio Mino works
extremely well for speech and music. You can use the built-in microphones or
use an external sound source. As an external sound source you can choose an
inductive loop, an external microphone or you can connect the Stereo Cable Set
to a stereo sound source.
Symbols and indicators
The following symbols are used in the user manual and can be explained as fol-
lows:
The warning triangle indicates information which must be followed in
order to guarantee operation and also in some cases to ensure personal
safety.
The light bulb (tip, note) indicates information which can be useful to help
you get the most out of the product.
9 or 10).
+ -
i
(6) to start Mino.
(9) raising and
+ -
(12) increasing and
>
(10) lowering
EN
(11) reducing
<
i
21