Bellman Audio Mino Manual Del Usuario página 24

External microphone
You can connect an external microphone to the external sound source input (16).
The External Sound LED (4) will light up orange at the same time to indicate that
the sound is coming from an external microphone.
The input sensitivity is automatically adjusted to a suitable amplification when
an external microphone is connected.
Combined signal sources
When you are listening via an External Sound Source, this sound can be combined
with the sound that the internal microphone is receiving.
Choose to listen to the External Sound Source by pressing the T button (7).
Hold down the button (5) until both the MIC LED (2) and T LED (4) light up.
M
The sound from the external sound source is now mixed with the sound from the
internal microphone. You can adjust the balance between the external sound and
the internal microphone by holding down the button (5) at the same time as
M
setting the balance using the (11) or (12) button.
< >
If you want to go back to listening to external sound, press the T button (7) and
if you want to switch over to listening on the internal microphone, press the
M
button (5) instead.
Battery indicator
The Battery Status LED (3) normally lights up green. This indicates that the unit is
switched on and the battery level is satisfactory.
When the battery is low, the Battery Status LED (3) blinks green until the battery
is almost completely flat when it blinks orange instead. As soon as it blinks green,
it is time to charge the unit again. If the unit is not charged, it is switched off
automatically.
Charging starts automatically when you connect a charger to the Charging Socket
(14). Charging in progress is indicated on the unit by an orange light. Once the
battery is fully charged, the indicator changes to green and the battery is
continuously trickle charged until the charger is disconnected.
24