Intended Use; Screwdriver Safety Warnings; Charger Safety Warnings - Ryobi ERGO Traducción De Las Instrucciones Originales

Safety, performance, and dependability
have been given top priority in the design
of your screwdriver.

INTENDED USE

The product is intended to be used only by
adults who have read and understood the
instructions and warnings in this manual,
and can be considered responsible for
their actions.
The product is intended for fastening and
removing screws and bolts.
Do not use the product in any way other
than those stated for intended use.
NOTE: It is recommended to use pilot
holes prior to driving screws.
WARNING
Read all safety
instructions, illustrations
specifications provided with this
power tool. Failure to follow all
instructions listed below may result in
Save all warnings and instructions for
future reference.

SCREWDRIVER SAFETY WARNINGS

Hold the power tool by insulated
gripping surfaces, when performing
an operation where the fastener may
contact hidden wiring. Fasteners
contacting a "live" wire may make
exposed metal parts of the power tool
"live" and could give the operator an
electric shock.
Ambient temperature range for tool
during operation is between 0°C and
40°C.
Ambient temperature range for tool
storage is between 0°C and 40°C.

CHARGER SAFETY WARNINGS

Before using battery charger, read all
instructions and cautionary markings
in this manual, on battery charger,
battery, and product using battery to
prevent misuse of the products and
Do not use charger outdoors or expose
to wet or damp conditions. Water
entering charger will increase the risk
of electric shock.
Use
recommended or sold by the battery
charger manufacturer may result in a
persons. Following this rule will reduce
the risk of electric shock, fire, or serious
warnings,
and Do not abuse cord or charger. Never
use the cord to carry the charger.
Do not pull the charger cord rather
than the plug when disconnecting
from receptacle. Damage to the cord
or charger could occur and create
an electric shock hazard. Replace
damaged cords immediately.
Make sure cord is located so that it
will not be stepped on, tripped over,
come in contact with sharp edges or
to damage or stress. This will reduce
the risk of accidental falls, which could
which could result in electric shock.
Keep cord and charger away from
heat to prevent damage to housing or
internal parts.
Do not operate charger with a
damaged cord or plug, which could
cause shorting and electric shock. If
damaged, have the charger replaced
by an authorised serviceman.
of an attachment
English |
EN
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
not
RO
LV
LT
ET
HR
SL
SK
BG
UK
TR
EL
1