Publicidad
Step 13
Carefully turn your unit over onto its front edges. For support, place packing foam and magazines underneath the unit as shown.
å
Place the SMALL BACK (S) over the small opening near the bottom of your unit.
å
Make equal margins along all four edges of the SMALL BACK (S). Fasten the SMALL BACK (S) to your unit using the NAILS (1N).
å
Unfold the LARGE BACK (R) and lay it over your unit.
å
Before fastening the LARGE BACK (R), push the SAFETY STRAP (60M) through the hole.
å
Make equal margins along the top and side edges of the LARGE BACK (R). Push on opposite corners of your unit if
å
needed to make it "square". The LARGE BACK (R) will overlap the SMALL BACK (S) as shown in the large diagram below.
Fasten the LARGE BACK (R) to your unit using the remaining NAILS (1N).
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
NAIL
(62 used in this step)
www.sauder.com/services
1N
S
60M
R
The LARGE BACK (R) will
overlap the SMALL BACK (S).
422180
Before fastening
the BACK, push the
SAFETY STRAP
through the hole.
For support, place packing
foam and magazines here.
R
S
Page 17
Publicidad
