Publicidad
Step 23
NOTE: The LARGE BUSHING WITH SMALL HOLE will go against the ENDS (A and B) Follow the large diagrams for the
å
correct placement of BUSHINGS.
While holding the lower SHOE RACK, fasten a set of BUSHINGS to the ENDS (A and B) as shown. Use two SILVER 9/16"
å
PAN HEAD SCREWS (138S).
Repeat steps 22 and 23 to fasten the middle and upper SHOE RACKS.
å
NOTE: If you decide to move the STORAGE UPRIGHT (M), you must remove the complete SHOE RACK from the unit.
å
SILVER 9/16" PAN HEAD SCREW
(6 used in this step)
LARGE BUSHING
WITH SMALL HOLE
LARGE BUSHING
WITH LARGE HOLE SMALL
www.sauder.com/services
138S
B
BUSHING
A
M
422180
SILVER 9/16" PAN HEAD SCREW
(6 used in this step)
LARGE BUSHING
WITH LARGE HOLE
SMALL
BUSHING
LARGE BUSHING
WITH SMALL HOLE
138S
Page 27
Publicidad
