ELICA UP Montaje Y Modo De Empleo página 16

Maintenance of the remote control
Cleaning the remote control:
Clean the remote control with a damp cloth and a neutral
solution of detergent without abrasive substances.
Changing the battery:
• Open the battery casing.
• Replace the flat batteries with 3 new 1.5 V type AAA
batteries.
Respect the polarity indicated in the battery casing when
inserting the new battery!
• Close the battery casing up again.
Disposal of the batteries
Ultimate disposal of the batteries should be handled according
to all national laws and regulations. Do not place used
batteries in your regular waste.
Ultimate disposal of the batteries must be done
Contact your local waste management officials for other
information regarding the environmentally sound collection,
recycling, and disposal of the batteries.
Operation anomalies
The hood does not work
Make sure that:
• There is no current blackout
• A speed has been effectively selected.
• The red reset button located above the filters inside the
hood is pressed.
The hood has low efficiency
Make sure that:
• The motor speed selected is sufficient for the quantity of
fumes present
• The kitchen is aired enough to allow an air intake and the
charcoal filter is not worn out (filter version hood).
• The air outlet pipe is not clogged.
Maintenance
Warning! Before any cleaning or maintenance operation,
disconnect the hood from the mains by removing the plug
or disconnecting the main switch of the house, or by
pressing the red button inside the hood, above the grease
filters.
Cleaning
The cooker hood should be cleaned regularly (at least with the
same frequency with which you carry out maintenance of the
fat filters) internally and externally. Clean using ONLY the
cloth dampened with neutral liquid detergent. DO NOT
CLEAN WITH TOOLS OR INSTRUMENTS. Do not use
abrasive products. DO NOT USE ALCOHOL!
Warning! Failure to carry out the basic cleaning
recommendations of the cooker hood and replacement of the
filters may cause fire risks.
Therefore, we recommend observing these instructions.
The manufacturer declines all responsibility for any damage to
the motor or any fire damage linked to inappropriate
maintenance or failure to observe the above safety
recommendations.
Panel
Panel replacement
The panel replacement is done by first opening it as indicated
in chapter opening panel; in the case of the LIGHT panel, you
must disconnect the power from the mains and unplug the
power cord of the lamps by acting on the electrical connector
located right above the panel.
Remove the two locknuts securing the panel (see fig. 12) and
slide the panel to the right to remove it from its seat.
To place the panel back into position, follow the above
described procedure in reverse order.
Grease filter
Traps cooking grease particles.
safely.
This must be cleaned once a month (or when the filter
saturation indication system – if envisaged on the model in
possession – indicates this necessity) using non aggressive
detergents, either by hand or in the dishwasher, which must
be set to a low temperature and a short cycle.
When washed in a dishwasher, the grease filter may discolour
slightly, but this does not affect its filtering capacity.
The grease filters installation and removal is done by opening
the panel as described in section "Panel Opening."
Charcoal filter (filter version only)
It absorbs unpleasant odours caused by cooking.
The saturation of the charcoal filter occurs after more or less
prolonged use, depending on the type of cooking and the
regularity of cleaning of the grease filter.
In any case it is necessary to replace the cartridge at least
every four mounths.
The charcoal filter may NOT be washed or regenerated.
15