Electrical Connection - ELICA UP Montaje Y Modo De Empleo

Panel opening
The opening of the panel can be done by pulling on the side
opposite the hinges, in correspondence of the LED that
indicates the speed of the suction motor (fig. 9). Accompany
the panel with your hands during the opening.
Following the panel opening, you can access the grease filter
and after its removal, acting on the appropriate handle, you
can reach the seat of the charcoal filter (fig. 10).
To close the panel, simply bring it in horizontal position until it
the automatic closing coupling occurs.
Ducting systems
It is possible to install an "UP" extractor hood with one or two
additional optional modules in a single suction system, thus to
connect it to a single remote suction motor inside or outside
the house.
A suction system, consisting of several elements, is operated
by a single remote control as only a hood (UP) has all the
electronic components needed for the operation, while the
remaining UP
OPTIONAL MODULE are dependent to the main UP hood.
The connections between the main hood (UP) and the
remaining UP OPTIONAL MODULE must be made in the
following ways:

Electrical connection

The hood must be connected to the mains supply by qualified
and trained technicians.
The mains power supply must correspond to the rating
indicated on the plate situated inside the hood. If provided with
a plug connect the hood to a socket in compliance with current
regulations and positioned in an accessible area, after
installation. If it not fitted with a plug (direct mains connection)
or if the plug is not located in an accessible area, after
installation, apply a double pole switch in accordance with
standards which assures the complete disconnection of the
mains under conditions relating to over-current category III, in
accordance with installation instructions.
Warning! Before re-connecting the hood circuit to the mains
supply and checking the efficient function, always check that
the mains cable is correctly assembled.
Warning! Power cable replacement must be undertaken by
the authorised service assistance centre or similar qualified
person.
Caution! Do not cut the cable between the hood and the
engine to avoid losing your right to warranty!
Mounting
Before starting to mount the appliance, make sure that no
component is damaged, otherwise contact the dealer and stop
mounting. In addition, read all the instructions below carefully.
13