Assembly with a separate speaker system
If you are using a speaker system other than the S-2EX, note
that you will have to use a hand drill (or the like) to make
holes on the speaker base to secure it to the stand. Make
sure the speaker weight does not exceed 29 kg.
After making holes on the speaker base where indicated
(make sure they line up with the screw holes on the speaker
support), secure the speaker to the speaker support using
commercially available wood screws as shown below.
Speaker
base
Speaker
support
Cabinet and stand maintenance
• Use a polishing cloth or dry cloth to wipe off dust and
dirt.
• If the cabinet or stand is very dirty, use a soft cloth
dipped in some neutral cleanser diluted 5 or 6 times
with water. Finally, wipe again using a dry cloth. Do not
use furniture wax or cleaners.
• Never use thinners, benzine, insecticide sprays and
other chemicals on or near the cabinet or stand, since
these will corrode the surfaces.
4
En
Specifications
External dimensions ............... 400 (W) x 604 (H) x 513 (D) mm
Weight .............................................................................. 17.8 kg
Supplied accessories
Stand base plates ...................................................................... 2
Speaker supports ....................................................................... 2
Stems .......................................................................................... 4
Spikes (with attached nuts) [SBA6053] ................................... 8
Spike bases [SLA1057] .............................................................. 8
Screws (Bind head, M5xL62) [SBA6050] ................................. 4
Screws (Bind head, M5xL36) [SBA6048] ................................. 4
Screws (Bind head, M6xL40) [SBA6054] ............................... 24
Spring washers [SBE6005] ........................................................ 4
Washers [SBE6006] ................................................................... 4
These operating instructions [SRD6045] ................................. 1
• Specifications and design subject to possible modifica-
• The product number are listed above in square brackets.
Fastening nut
Screw holes
for securing
speaker
Commercially
available wood
screw
Private households in the 25 member states of the EU, in
Switzerland and Norway may return their used electronic
products free of charge to designated collection facilities or to a
retailer (if you purchase a similar new one).
For countries not mentioned above, please contact your local
authorities for the correct method of disposal.
By doing so you will ensure that your disposed product under-
goes the necessary treatment, recovery and recycling and thus
prevent potential negative effects on the environment and
human health.
tion without notice, due to improvements.
Replacement part numbers
Part name
• Protector (Bottom)
• Protector (Middle)
• Protector (Top)
• Protector
• Packing case
• Protection sheet
• Protection sheet
• Protection sheet
If you want to dispose this product, do not mix it with
general household waste. There is a separate collection
system for used electronic products in accordance with
legislation that requires proper treatment, recovery and
recycling.
Published by Pioneer Corporation.
Copyright © 2005 Pioneer Corporation.
Part no.
SHA6095
SHA6096
SHA6097
SHA6098
SHG6150
SHC6044
SHC6045
SHC6046
All rights reserved.